Hydropneumatics system consists of 2-6 high pressure multistage centrifugal pump sets, suction and delivery manifolds with valves, a base frame and suitable control panel. As soon as you open a tap, the pressure in the tank is reduced as the water level goes down. As soon as the pressure level drops to a certain level, the pressure switch senses it and turns on the pumps and turns it off when the desired level of pressure is achieved. The system is pre-assembled, tested in the factory and ready for installation at the site.
The Air Compressor Receiver and Dryer compresses, stores and delivers clean, dry compressed air for the Intermittent Supersonic Wind Tunnel. It has a compressor, storage tanks (air receivers), dryers and filters to clean and remove moisture from the air. JSK PROCESS SOLUTION can helps to selection of Air Compressor system according to the application. It may be reciprocating compressor or screw compressor. We can supply the reputed make air compressor and its spares.
A cooling tower is a heat removal device that uses water to transfer process waste heat into the atmosphere. Likewise, an industrial cooling tower operates on the principle of removing heat from water by evaporating a small portion of water that is recirculated through the unit. JSK PROCESS SOLUTION Suggest and supply the cooling tower system and spares parallel to fabrication services for the same.
Refrigeration System is pioneer need for Dairy Industries. There are many options for the selection of refrigeration system according to the requirements of Industries. Air Cooled Feon based system for the micro and small scale plant. VAM ( vapor absorption chiller machine ) and Ammonia based system for the giant industries which includes Ammonia compressor, receiver, condenser etc. JSK PROCESS SOLUTION can helps for the selection one of the above system suitable to application and necessity. Also helps for erection and commissioning of the system.
JSK PROCESS SOLUTION provides technical support for selection of Industrial Steam Boiler, Hot water generator & Thermic Boiler selection according to application. Boiler selection depends on different criteria likes requirements of Heat transfer, availability of Fuel, Application and location of Plant. Boiler should be Wood fired, Coal fired, Gas fired, Diesel fired or electrical. Prevention of water wastage and lower fuel consumption we suggest proper condensate recovery System. Our Highly Skilled Engineer monitor the complete supervision at the time of Installation and Commissioning.
31st May 2024
31st May 2024
INDUSTRIAL CABLING, LAYING & TERMINATION SERVICE
31st May 2024
31st May 2024
.jpeg){kind=logo}